Rockwell Automation 1772-LV Mini-PLC - 2/15 Programmable Controller (Series B) Programming and Operations - Manual (Page 191)

Quick Reference Section
Appendix A
AĆ22
Function Description Mode Key Sequence
[INSERT]
[T.END]
Position the cursor on the instruction that will
precede the temporary end instruction. The
remaining rungs, although displayed and
accessible, are not scanned.
Removing a temporary
end instruction
[REMOVE]
[T.END]
Program Position cursor on temporary end instruction and
press key sequence.
NOTE: When in test mode, the processor will hold outputs off regardless of attempts to force them on.
Table A.P
Report Generation Commands
Command Key Sequence Description
Enter report generation function [RECORD][DISPLAY] or
Set baud rate,
Message Code Keys)
Puts industrial terminal into report generation
function.
Same (entered from a peripheral device).
Message store [M][S][,] (Message Number)
[RETURN]
Stores message in processor memory. Use [ESC]
to end message.
Message print [M] [P] [,] (Message Number)
[RETURN]
Prints message exactly as entered.
Message report [M][R][,}(Message Number)
[RETURN]
Prints message with current data table values or bit
status.
Message delete [M][D][,] (Message Number)
[RETURN]
Removes message from processor memory.
Message Index [M][I][RETURN] Lists messages used and the number of words in
each message.
Automatic report generation [SEARCH][4}[0} or
[M][R][RETURN]
Allows messages to be printed through program
control.
Same (entered from a peripheral device).
Exit automatic report generation [ESC] or [CANCEL COMMAND] Terminates automatic report generation.
Same (entered from a peripheral device).
Exit report generation function [ESC] or [CANCEL COMMAND] Returns to ladder diagram display.
Same (entered from a peripheral device).
NOTE: [CANCEL COMMAND] can only be used if the function was entered by a command from a peripheral device.