Rockwell Automation 1772-LV Mini-PLC - 2/15 Programmable Controller (Series B) Programming and Operations - Manual (Page 123)

Chapter
10
10Ć1
Block Format Instructions
In this chapter you will read sections A thru C concerning:
How to expand the data table.
How to enter a file instruction.
How to load data into the hexadecimal data monitor display.
How to edit your file data.
How to document a sequencer input and output instruction.
How to enter a sequencer input and output instruction.
How to load data into the binary data monitor display.
Section A
File Instruction Programming
In this section you will read:
How to expand the data table.
How to enter a file instruction.
How to load data into a hexadecimal data monitor display.
As you recall from chapter 6, there are three types of file instructions:
File to file move
File to word move
Word to file move
We will show you how to enter the file to file move instruction, but the syntax is
the same for each file instruction.
Objectives
Objectives
File Instructions