Rockwell Automation 1784-KTS_KTX_KTXD User Manual Communication Interface Card - Manual (Page 24)

2-8 Configure the Card Hardware
1784-6.5.22 - November 1999
Important: If you are using the “no interrupt” setting, you must place the
jumper vertically over two pins on the right-side row as shown.
This way you can save the jumper for future use. Placing the
jumper on the left-side row will cause interrupt problems on the
motherboard.
If you are: Then:
using the card’s default interrupt settings, i.e.,
no interrupt go to the next section, Installing the Card
Inside the Computer
setting new interrupts move the jumper to the new interrupt
location(s) (as entered on Table 2.E,
page 2-10)
CH2 CH1
CH2
3
4
5
7
9
10
11
12
15
CH1
3
4
5
7
9
10
11
12
15
INTERRUPTS
30555