Rockwell Automation 1784-KTS_KTX_KTXD User Manual Communication Interface Card - Manual (Page 42)

4-8 Connect the Interface Card
1784-6.5.22 - November 1999
Connect the Card via a DH-485 Network
Figure 4.1 shows an example of a network consisting of three SLC 500
controllers and one programming station. This configuration requires the
1784-KTX or -KTXD card and three link couplers:
• An SLC 500 CPU is connected to each of the link couplers (1747-AIC) with a
1747-C11 cable.
• The 1784-KTX or -KTXD card is connected to the network at one of the link
couplers, as shown in Figure 4.1.
• The communication cable consists of three segments of cable daisy-chained
at each link coupler.
Figure 4.1 Communicate to multiple SLC 500s via the DH-485 network
To
1784-KT x Card
Communication Cable
Belden #9842
Link
Coupler
1747-AIC
Link
Coupler
1747-AIC
Link
Coupler
1747-AIC
1747-C11
1747-C11
1747-C11
SLC 500 Controller
SLC 500 Controller
SLC 500 Controller
42139