Rockwell Automation 1784-KTS_KTX_KTXD User Manual Communication Interface Card - Manual (Page 72)

B-8 Run the 1784-KTx Diagnostics for DOS
1784-6.5.22 - November 1999
Define a KT x Card to Test
If you have more than one KTx card installed or you are using a 1784-KTXD
card, you need to define which card or which memory address you want to test
Important: If you need to use settings other than the default settings, you must
define those settings on this screen.
1. From the main menu (see page B-7), press F2.
You see:
2. Change the configuration to match the settings for the KTx card that you
want to test.
To change the: Press this key until you see the setting that you need:
memory address F4 (Set Memory)
interrupt F5 (Set Intrrpt)
DH-485 baud F8 (DH485 Baud)