Rockwell Automation 1784-KTS_KTX_KTXD User Manual Communication Interface Card - Manual (Page 43)

Connect the Interface Card 4-9
1784-6.5.22 - November 1999
Connect the Card to an SLC 500 Processor
Figure 4.2 shows an example of a point-to-point link consisting of an SLC 500
processor and a programming station. This configuration requires the 1784-KTX
or -KTXD card and an SLC 500 processor. The SLC 500 CPU is connected
directly to the 1784-KTX or -KTXD card with a 1784-CP14 cable, as shown.
Figure 4.2 Communicating to a single SLC 500 using a point-to-point DH-485 link
To connect an SLC family processor to the KTx card, you:
1. Connect the termination resistor end of the CP14 cable to the KTx card.
2. Connect the RJ-45 connector directly to the phone-jack connector on the front
of the SLC processor.
To the 1784-KT x Card
SLC 500 Controller
1784-CP14 Cable
Personal
Computer
42140
6-pin Phoenix connector with
switchable termination resistor
RJ-45 connector
1784-CP14 cable
10.5 ft
(3.20m)
42141