Rockwell Automation 1784-KTS_KTX_KTXD User Manual Communication Interface Card - Manual (Page 26)

2-10 Configure the Card Hardware
1784-6.5.22 - November 1999
Table 2.E Jumper Settings
Important: If you are using the “no interrupt” setting, you must place the
jumper vertically over two pins on the right-side row as show on
page 2-7. This way you can save the jumper for future use. Placing
the jumper on the left-side row will cause interrupt problems on the
motherboard.
Record the interrupt setting for the 1784-KT x card’s channel 1:
Card:
Slot number
Using default address: Yes No
If no, new interrupt:
Record the interrupt setting for the 1784-KT x card’s channel 2:
Card:
Slot number
Using default address: Yes No
If no, new interrupt:
CH1
3
4
5
7
9
10
11
12
15
CH2
3
4
5
7
9
10
11
12
15