Rockwell Automation 1784-KTS_KTX_KTXD User Manual Communication Interface Card User Manual
Page 81
Run the 1784-KTx Diagnostics for DOS
B-17
1784-6.5.22 - November 1999
3. Use the decision table below for both protocols.
4. Press F4 to enable the card.
If everything is operating successfully, you see the message:
•
DH+ Enabling Test . . . . . ENABLED
for DH+
•
DH485 Enabling Test . . . . . ENABLED
for DH-485
5. Press F6 to view the card’s information.
For DH+
To:
Press this key:
enable the KT
x
card on a DH+ or DH-485 link (page B-17)
F4 Enable
disable the KT
x
card from a DH+ or DH-485 link (disables the card
from the network but protocol is not removed from the card)
F5 Disable
display the KT
x
car d on DH+ or DH-485 link
F6 Display
clear the memory location of the KT
x
card
•
disables card from the DH+ or DH-485 link
•
clears the DH+ or DH-485 protocol from the card
F7 Clear
return to the main menu (page B-7
F10 Return