Rockwell Automation 1784-KTS_KTX_KTXD User Manual Communication Interface Card - Manual (Page 86)

C-2 Use the KTx Card with 6200 Software
1784-6.5.22 - November 1999
2. Install the card in the computer by following the instructions in Chapter 3.
Important: The following procedure to run the installation program is not
necessary with later versions of software. If your software lists the
KTx as an option, the utility is already installed.
3. Run the installation program on the KTx Utility Disk, which came in the box
with your KTx card.
A. Insert the utility disk in drive A.
B. Type: a:
C. Type: install c
4. Select the ‘update’ routine specific to your processor.
• Update 6200 series for PLC 3 files . . .
• Update 6200 series for PLC 2 files . . .
5. Select the ‘update’ routine for the KTx files.
For a PLC-3 processor, select: