Rockwell Automation 1784-KTS_KTX_KTXD User Manual Communication Interface Card - Manual (Page 85)

1784-6.5.22 - November 1999
Appendix
C
Use the KTx Card with 6200 Software
You can use the KTx card with Allen-Bradley PLC-2

, PLC-3

, PLC-5

, and
PLC-5/250 programmable controllers using 6200 software.
KT x Card and 6200 Software
for PLC-5 and PLC-5/250 Programmable Controllers
Current versions of Allen-Bradley 6200 software for PLC-5 and PLC-5/250
programmable controllers have built-in support for the KTx card. If your version
does not support the KTx card, you must upgrade to the latest version of 6200
software before attempting to connect.
KTX Card and 6200 Software
for PLC-2 Direct-connect and PLC-3 Direct-connect
Important: You can use only the 1784-KTX card for PLC-2 and PLC-3
direct-connect. The 1784-KTS and 1784-KTXD do not support
direct connection to a PLC-2 or PLC-3 processor.
To use the KTX card for direct-connect operation to a PLC-2 or PLC-3
programmable controller, follow these steps:
Important: The screen prints presented here may not contain the same part and
release number as your KTx Utility software.
1. Set the memory address on the card to one of the following:
See Chapter 2 for additional information.
• CB00: • D300: • DB00:
• CF00: • D700: • DF00: