Rockwell Automation 1747-PTxx Getting Started Guide for HHT - Manual (Page 10)

Chapter 1
Setting Up Your Equipment
Getting Started Guide
for HHT
1–3
SLC 500 demo units are available with either a fixed controller or modular
controller. This guide assumes you are using a modular controller demo unit
for all the programming exercises. If you use a fixed controller demo unit,
you will need to use different configuration information and I/O addresses in
the exercises. This is explained later.
The figure below shows an SLC 500 modular controller demo unit. It is
completely wired, with 12 external inputs (6 push buttons and 6 selector
switches) and 8 external outputs (pilot lights).
Note the On/Off Power Switch and the Power Supply Receptacle on the
demo. Make certain that the power switch is Off, then insert one end of the
power cord into the power supply receptacle and the other end into an
electrical socket.
On/Off Power
Switch
Pilot Light
Selector Switches
6 0
O
F
F
O
N
6
0
O
N
6
O
F
F
1 0 2
Input/Output
Panel
Combination
Pilot Light/Pushbuttons
SLC 500 Modular Controller
Power Supply
Receptacle
Setting Up a Demo Unit