Rockwell Automation 1747-PTxx Getting Started Guide for HHT - Manual (Page 50)

Appendix A
Additional Ladder Program Exercises
Getting Started Guide
for HHT
A–3
Inserting an Instruction
11. Press [ESC] once, then [F1] – INS_INST , then [F1] – BIT , then
[F3] —( )— .
12.Type the bit address O:3/1 , then [ENTER] . Then press [F5] – ACCEPT .
The following display appears:
F1 F2 F3 F4 F5
] [
>
( )
2.0.1.1.4
OFL
] [ ( )
—] [— —]/[— —( )— —(L)— —(U)—
OTE:O0:3.0/1 NO FORCE
<END>
Saving the Program
13.Press [ESC] twice. Then press [F5] – ACP_RNG . Then press [ENTER] .
14.Press [F5] – SAVE_EX , then [F5] – ACCEPT . The following display
appears:
File Name: Prog Name:1000
File Name Type Size(Instr)
0 System 76
1 Reserved 0
2 Ladder 4
F1 F2 F3 F4 F5
CHG_NAM CRT_FIL EDT_FIL
OFL
DEL_FIL > MEM_MAP
15.Press [ESC] once.
Downloading the Program
Start with the main display.
1. Press [F5] – UTILITY .
2. Press [F2] – WHO .
3. Press [F3] – ATTACH .
4. Put processor into PROGRAM mode: press [F4] – MODE , then
[F5] –PROGRAM , then [F2] – YES . Then press [ESC] .
5. Press [F3] – DWNLOAD , then [F2] – YES . The following display appears:
File Name: Prog Name:1000
File Name Type Size(Instr)
0 System 76
1 Reserved 0
2 Ladder 4
F1 F2 F3 F4 F5
OFFLINE UPLOAD DWNLOAD
PRG
MODE > CLR_PRC