Rockwell Automation 1747-PTxx Getting Started Guide for HHT - Manual (Page 38)

Chapter 3
Creating a Program
Getting Started Guide
for HHT
3–13
Entering an “Output Energize” Instruction
1. Press [F3] , for the output energize instruction. The following display
appears:
ENTER BIT ADDR:
ZOOM on OTE
NAME: OUTPUT
ENERGIZE
BIT ADDR:
F1 F2 F3 F4 F5
2.0.0.0.* ( )
2. Type bit address O:3/0 , then [ENTER] . (If you entered the wrong
instruction by mistake, just press [ESC] and try again.)
3. Press [F5] – ACCEPT , then press [ESC] twice. Then press
[F5] – ACP_ RNG . The following display appears:
<END>
F1 F2 F3 F4 F5
>
2.1.0.0.*
INS_RNG MOD_RNG SEARCH DEL_RNG UND_RNG
OFL
] [ ( )
At this point the rung is entered and accepted.
4. Press [ENTER] to display more menu options.