Rockwell Automation 1747-PTxx Getting Started Guide for HHT - Manual (Page 16)

Chapter 1
Setting Up Your Equipment
Getting Started Guide
for HHT
1–9
After you install the memory pak and battery, and plug in the cable, you can
test operation of the HHT by powering up the controller (or plugging in the
Wall–Mount or Global Desk Top power supply).
When the HHT is energized, it will go through a series of diagnostic tests.
Then the following display is shown.
SLC 500 PROGRAMMING SOFTWARE Rel. 2.03
1747 – PTA1E
Allen–Bradley Company Copyright 1990
All Rights Reserved
F1 F2 F3 F4 F5
PRESS A FUNCTION KEY
SELFTEST TERM PROGMAINT
OFL
UTILITY
The HHT display format consists of the following:
•
Display area
•
Prompt/Data Entry/Error Message area
•
Menu tree functions
The figure below indicates what appears in these areas. (To access this
screen, press
[F3] – PROGMAINT .)
Prompt/Entry/Error Area
Menu tree functions are
directly accessible.
Menu function keys are selected
with
[F1] to [F5] keys. When the > symbol is present, pressing
[ENTER] will toggle additional menu functions.
File Name: 101 Prog Name: 1492
File Name
Type Size(Instr)
0 System *
1 Reserved *
2 101 Ladder
*
CHG_NAM CRT_FIL EDT_FIL DEL_FIL MEM_MAP >
F1 F2 F3 F4 F5
OFL
Display Area
Indicates that the HHT is offline.
This section is intended only as a brief preview of keyboard operation.
Beginning in chapter 3, you will become familiar with the keyboard as you
are guided through various programming procedures.
Menu Function Keys (F1, F2, F3, F4, F5)
The top row of purple keys, F1 through F5, are menu function keys. They
select the menu functions at the bottom of the screen. Note that when the >
symbol is present, the
[ENTER] key will toggle additional menu functions (if
any) at a particular menu level. The [ESC] key exits the display to the
previous menu level.
HHT Powerup
HHT Display Format
The Keyboard