Rockwell Automation 1747-PTxx Getting Started Guide for HHT - Manual (Page 34)

Chapter 3
Creating a Program
Getting Started Guide
for HHT
3–9
6. Press [F2] – MOD_SLT.
7. Assign 1746–IA8 in slot 2: press the [
↓
] key twice, then [ENTER] . The
following display appears:
Rack 1 = 1746–A4 4–SLOT RACK
Rack 2 = NONE
Rack 3 = NONE
Slot 0 = 1747–L511
CPU–1K USER MEMORY
Slot 2 = 1746–IA8 8–INPUT 100/120 VAC
F1 F2 F3 F4 F5
MOD_RCK MOD_SLT DEL_SLT UND_SLT
8. Call up slot 3 using the cursor key. Press the [
↓
] key once.
9. Press [F2] – MOD_SLT .
Slot 3 = NONE appears on the prompt line.
10.Assign 1746–OA8 in slot 3: press the [
↓
] seven times. Then press
[ENTER] . The following display appears:
Rack 1 = 1746–A4 4–SLOT RACK
Rack 2 = NONE
Rack 3 = NONE
Slot 0 = 1747–L511
CPU–1K USER MEMORY
Slot 3 = 1746–OA8 8–OUT(TRI) 100/240 VAC
F1 F2 F3 F4 F5
MOD_RCK MOD_SLT DEL_SLT UND_SLT
Your controller is now fully configured.
11. Press [ESC] . This returns you to the display shown below.
File Name: Prog Name:1000
File Name Type Size(Instr)
0 System *
1 Reserved *
2 Ladder *
F1 F2 F3 F4 F5
EDT_DAT SEL_PRO EDT_I/O
OFL
CLR_MEM >