Rockwell Automation 1747-PTxx Getting Started Guide for HHT - Manual (Page 53)

Appendix A
Additional Ladder Program Exercises
A–6
3. Enter a rung and an XIC instruction. Press or enter the following:
A. [F1] – INS_RNG
B. [F1] – INS_INST
C. [F1] – BIT
D. [F1] —] [—
E. I:1/0
F. [ENTER]
G. [F5] – ACCEPT
H. [ESC]
4. Enter the Timer Instruction. Press or enter the following:
A. [F2] – TMR/CNT
B. [F1] – TON
C. T4:0 (This is the Timer Address.)
D. [ENTER]
E. 1000 (This is the Timer Preset Value in hundredths of a second.)
F. [ENTER]
G. 0 (This is the Timer Accumulated Value.)
H. [ENTER]
I. [F5] – ACCEPT
J. [ESC]
K. [ESC]
L. [F5] – ACP_RNG
5. Enter a second rung and an XIC instruction. Press or enter the following:
A. [F1] – INS_RNG
B. [F1] – INS_INST
C. [F1] – BIT
D. [F1] —] [—
E. T4:0/14 (14 represents the timer timing bit.)
F. [ENTER]
G. [F5] – ACCEPT
<END>
] [
<END>
] [ ( TON )
<END>
] [
] [ ( TON )