Rockwell Automation 1747-PTxx Getting Started Guide for HHT - Manual (Page 14)

Chapter 1
Setting Up Your Equipment
Getting Started Guide
for HHT
1–7
3. Locate the Communications Port of the controller. The figure below
shows where it is located on modular and fixed controllers.
Processor Module
(Modular Controller)
SLC 500 Fixed Controller
(Communication Port)
(cover open)
Connectors are keyed. Connect one end of the 1747–C10 communication
cable to the top of the HHT. The other connector plugs into the
communication port on the front of the fixed I/O controller, or into the
communication port on the front of the CPU module of modular controllers.
SLC Controller
(Modular)
1747–C10 Cable
HHT
If you are using a 1747–NP1 Wall–Mount power supply or a 1747–NP2
Global Desk Top power supply, plug the communication cable connector into
the socket provided.