Rockwell Automation 1747-PTxx Getting Started Guide for HHT - Manual (Page 51)

Appendix A
Additional Ladder Program Exercises
A–4
6. Monitor the ladder program and put the processor into the RUN mode.
To do this, press [ENTER] , then [F5] – MONITOR , then press 2 , then
[ENTER] .
7. Press [F1] – MODE , then [F1] – RUN , then [F2] – YES , then [ESC] .
Testing the Ladder Program
1. Press pushbutton #0. Outputs #0 and #1 turn ON. The following display
appears.
<END>
F1 F2 F3 F4 F5
] [ ( )
2.0.0.0.*
RUN
] [ ( )
MODE FORCE SEARCH
These output instructions become bold.
This input instruction becomes bold.
EDT_DAT
2. Release pushbutton #0. Outputs #0 and #1 turn OFF.
3. Press pushbutton #1. Outputs #0 and #1 turn ON. The following display
appears.
<END>
F1 F2 F3 F4 F5
] [ ( )
] [ ( )
These output instructions become bold.
This input instruction becomes bold.
RUN
2.0.0.0.*
MODE FORCE SEARCH EDT_DAT
4. Release pushbutton #1. Outputs #0 and #1 turn OFF
To return to the main display, press [ESC] and respond YES to any prompts
until the main display appears.