Rockwell Automation 1794-IJ2XT FLEX I/O Frequency Input Modules User Manual - Manual (Page 43)

Publication 1794-6.5.11 - September 2011
Configure Your FLEX I/O Module with RSLogix 5000 Software 33
You should now see the 1794-IJ2 module added to your
I/O Configuration tree.
To be able to check if your configured parameters are acceptable and the
configuration is successful, you need to go online.
Refer to the RSLogix 5000 Online Help for detailed descriptions of the
configuration parameters.
Chapter Summary This chapter provided instructions and required parameters for setting up your
FLEX I/O module on an EtherNet/IP network.
Configuration Parameters
Module Property Configuration Options
Maximum Frequency 0 Hz (default)
Frequency Range 1…32767
1.0…3276.7
Minimum Frequency Sample Time 2…100
Acceleration Calculation Time Rolling Average
8
16
32
Missing Pulse Multiplier None
2
8
32
Pulses to Terminate Sampling Minimum Frequency Sample Time
2
4
8
16
32
Wire-off/Missing Pulse Fault Select
Mode Disabled
Alarm Only
Alarm/Maximum Frequency
Alarm/Minimum Frequency