Rockwell Automation 5370-CUPK Color CVIM USER-PAK Option - Manual (Page 19)

A–B
3
Chapter
3 – 1
Installation
Contents
Chapter Objectives 3–1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
The Two USER-PAK Memory Cards 3–1 . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installing the USER-PAK Option 3–1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Using the Setup Card 3–3 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Accessing Setup Mode with USER-PAK Installed 3–4 . . . . . . . . . . . . . . . . .
This chapter describes how to install the USER-PAK option in the
Allen-Bradley 5370-CVIMC Color CVIM module, including the use of the
two memory cards on which the USER-PAK option software resides.
The USER-PAK option is provided on two separate memory cards. These
two cards are labeled Installation / Key card and Setup card respectively.
The purpose of each card is described below:
•
Installation / Key card – This card serves two purposes: Use this card to
install the USER-PAK option into the Color CVIM module; use this card
also to access the setup mode in the case of lost passwords.
Important: Because this card can be used to override the Color CVIM
system security (see Chapter 4), it is suggested that this card be kept in a
secure place when not in use, and that access to this card be allowed only
to the appropriate authorized personnel.
•
Setup card – Insert this card into the Archive Memory slot after the
USER-PAK option has been installed. This card must remain in the
Archive Memory slot during setup mode in order to access most of the
USER-PAK option capabilities.
This section describes how to install the USER-PAK option. You need only
install the USER-PAK option once; once installed, the USER-PAK option
remains installed for all subsequent powerups.
To install the USER-PAK option in your Color CVIM module:
•
Remove DC power from the Color CVIM module.
•
Insert the Installation / Key card into the Archive Memory slot on the
Color CVIM module. Insert the end with the metal strip facing right (see
Figure 3.1, page 3 – 2):
Chapter Objectives
The Two USER-PAK
Memory Cards
Installing the USER-PAK
Option