Rockwell Automation 5370-CUPK Color CVIM USER-PAK Option - Manual (Page 21)

Chapter 3
Installation
3 – 3
•
Verify that the USER-PAK option is installed by checking the title banner
on the monitor after power-up; if the USER-PAK option is installed, there
is a message on the banner indicating the presence of the USER-PAK
option.
•
Remove the Installation / Key card from the Archive Memory slot.
Card Security: Because the Installation / Key card can be used to
override the Color CVIM system security (see Chapter 4), it is suggested
that this card be kept in a secure place when not in use, and that access to
this card be allowed only to the appropriate authorized personnel.
To access all of the USER-PAK features while in setup mode, the Setup card
must be inserted.
To insert the Setup card:
•
Insert the Setup card into the Archive Memory slot on the Color CVIM
module with the card’s metal strip facing right.
•
Leave the Setup card in the Archive Memory slot as required during your
configuration of the Color CVIM module.
Features for which Setup Card is not required: Most USER-PAK features
require the Setup card be inserted; the only features which do not require the
Setup card are
Change Password (see Chapter 4), and the Copy and Paste
feature for tools (see Chapter 9). When the Setup card must be inserted to
access a feature, this is specifically stated as appropriate in this manual.
Removing the Setup Card: You may remove the Setup card from the Color
CVIM module at any time – except when the Memory Active LED on the
Color CVIM module is ON. The Memory Active LED goes ON during setup
mode when certain USER-PAK features are used.
Do not remove the Setup card from the Archive Memory slot
when the Memory Active LED on the Color CVIM module is
ON. Doing so will cause the Color CVIM module to shut
down, which will result in the loss of your working
configuration (the internally-stored configuration is not
effected).
ATTENTION:
!
Restarting the Color CVIM module: If the Color CVIM module operation
has shut down due to Setup card removal with the Memory Active LED ON,
restart the Color CVIM module when appropriate by cycling Color CVIM
module power off and on again.
Using the Setup Card