Rockwell Automation 5370-CUPK Color CVIM USER-PAK Option - Manual (Page 63)

Chapter 7
Creating Custom Runtime Displays
7 – 4
This section describes the initial steps to use in defining a viewport. To
define a viewport:
•
Insert the Setup card into the Archive Memory slot on the Color CVIM
module.
•
Pick the Envir/Cam
→
Config. Output boxes to display the Config.
Output menu; this also displays the viewport, if a viewport is currently
selected (see Figure 7.2).
Figure 7.2 Example Custom Runtime Display
Viewport Border
Viewport 1 selected
Config. Output box selected
•
Select the specific viewport you are going to define using the
corresponding
Previous/Next boxes. The selected viewport appears on
the screen.
Picking the Next box repeatedly cycles though the selection of Viewports
1-40 , then Serial Port A , Serial Port B , then Viewports 1-40 , etc.
Picking and holding the Next or Previous box causes the Define
Viewport number to increment/decrement continually.
•
Pick the Viewport: Disabled box to enable the viewport (the box
changes to read Viewport: Enabled ) .
Note: You can disable a viewport after defining it. The viewport must be
enabled in order to be active during the configuration during operation.
Initial Setup: Selecting and
Defining the Viewport