Rockwell Automation 4100 AEC Absolute Encoder Converter Installation - Manual (Page 30)

Publication 4100-UM052B-EN-P - October 2001
22 Installation & Hook-Up
7. Use the screwdriver to tighten the clamping screw to the proper
torque (0.25 N-m/2.2 in-lb.).
8. Verify that the cable lead does not pull out of the terminal.
9.
The function of these connectors, their pinouts, and names are
defined in the following sections.
The SSI Connector
The SSI connectors are used to connect the absolute transducer to the
AEC. The pin layout and functionality for this connector are as
follows.
Cable Leads
If the cable lead: Do this:
Pulls out of the terminal Repeat steps 3 through 9
again
Does not pull out of the
terminal Repeat steps 3 through 9 for
the next terminal
SSI Connector Pin Functions
SSI Input
Pin Number Pin Function
1 Transducer Power +24V DC
2 Transducer Power +15V DC
3 Transducer Power +5V DC
4 Data -
5 Clock -
6 Shield
7 Transducer Power Return
8 Shield
9 Data +
10 Clock +