Rockwell Automation 1794-IP4 Series B FLEX I/O PULSE COUNTER User Manual - Manual (Page 40)

Chapter
4
Publication 1794ĆUM016B-EN-P - August
2002
Writing Configuration to and
Reading Status from Your
Module with a Remote I/O
Adapter
In this chapter, we tell you about:
For information on See page
Configuring Your Module . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-1
Reading Data from Your Module . . . . . . . . . . . . . . . . . . . . . . 4-2
Mapping Data for the Module . . . . . . . . . . . . . . . . . . . . . . . . 4-2
Pulse Counter Module (1794ĆIP4) Image Table Mapping . . . . . 4-2
Block Transfer Read Word Assignments . . . . . . . . . . . . . . . . 4-3
Bit/Word Definitions for Block Transfer Read Words . . . . . . . . 4-3
Block Transfer Write Word Assignments . . . . . . . . . . . . . . . . 4-4
Bit/Word Definitions for the Block Transfer Write Words . . . . . 4-5
The Pulse Counter module is configured using a group of data table
words that are transferred to the module using a block transfer write
instruction.
Some of the software configurable features available are:
•
number of inputs
•
encoder multiplier
•
gate function
•
latch function
•
rollover
Configure your module for its intended operation by means of your
programming terminal and write block transfers.
Note: Programmable controllers that use 6200 software (release 4.2
or higher) programming tools can take advantage of the IOCONFIG
Addendum utility to configure this module. IOCONFIG Addendum
uses menu–based screens for configuration without having to set
individual bits in particular locations. Refer to your 6200 software
literature for details.
Important: It is strongly recommended that you use IOCONFIG
Addendum to configure this module. The IOCONFIG
Addendum utility greatly simplifies configuration. If
the IOCONFIG Addendum is not available, you must
enter data directly into the data table. Use this chapter
as a reference when performing this task.
What This Chapter
Contains
Configuring Your Pulse
Counter Module