Rockwell Automation 6181F_P Series E Integrated Display Computers User Manual - Manual (Page 24)

24 Rockwell Automation Publication 6181P-UM002D-EN-P - February 2014
Chapter 2 Installation
Required Tools These tools are required for computer installation:
• #2 cross-head screwdriver
• Panel cutout tools (for panel mounting)
• Drill motor and drill bit (for wall mounting)
• Antistatic wrist strap
Install the Computer The computers support the following mounting options:
• Panel mount (display computer models)
• Wall mount (non-display computer models)
Panel Mounting Guidelines
Observe these guidelines when installing the computer in a panel:
• Remove all electrical power from the panel before making the cutout.
• Confirm that there is adequate space behind the panel. For specific
information, refer to Mounting Clearance Requirements on page 20.
• Cut supporting panels to specifications before installation. Take precautions
so metal cuttings do not enter components already installed in panel.
Supporting panels must be at least 14 gauge for proper sealing against water
and dust and to provide proper support. The mounting hardware supplied
accommodates panel thickness between 1.5…5.5 mm (0.06…0.22 in.).
• Make sure the area around the panel cutout is clear.
Panel Cutout Dimensions
Included with the shipped computer is 6181P and 6181X Industrial Computers
Cutout Template, publication
6181P-DS002 , which is a cutout template for each
computer model.
The computers must be mounted to meet the panel cutout dimensions specified
below.
ATTENTION: Failure to follow these guidelines can result in personal
injury or damage to the panel components.
Model Cutout Dimensions (H x W), approx
1200P 254.0 x 324.0 mm (10.0 x 12.76 in.)
1500P 285.0 x 386.6 mm (11.24 x 15.22 in.)
1700P 329.5 x 424.0 mm (12.97 x 16.69 in.)