Rockwell Automation 6181F_P Series E Integrated Display Computers User Manual - Manual (Page 40)

40 Rockwell Automation Publication 6181P-UM002D-EN-P - February 2014
Chapter 4 Component Replacement
CompactFlash Card The computers have a CompactFlash (CF) Type II card slot for loading CF cards:
• The standard computers have one CF slot on the right side of the computer.
• Performance and non-display computers have two CF slots: one on the
right side of the computer, and another on the I/O port panel below the
serial ports.
Load a Card in the Right CF Card Slot
Follow these steps to load a CF card in the card slot of all three computer models.
1. Follow the steps for Pre-configuration on page 36 .
2. Loosen the screw that secures the CF card slot cover (A).
3. Open the CF card slot cover (B).
4. Insert the CF card into the slot (C) until it is firmly seated.
5. Close the CF card slot cover (D).
6. Tighten the screw to secure the slot cover (E).
7. Follow the steps for Post-configuration on page 37 .
IMPORTANT The CF card slot on the right side of all computer models is not
hot-swappable. You must first shut down the computer before you can insert
or remove a card from this slot.
ATTENTION: When properly seated, more than 80% of the CF card easily
inserts into the slot before you encounter resistance. If you encounter
resistance before then, remove the card, rotate it 180°, and reinsert.
Do not force the card into the slot. Forcing the card into the slot can
damage the connector pins.
A
C
B
D
E