Rockwell Automation 6181F_P Series E Integrated Display Computers User Manual User Manual
Page 49
Rockwell Automation Publication 6181P-UM002D-EN-P - February 2014
49
Component Replacement
Chapter 4
8. Hold the new riser board by its edge and remove it from its protective
packaging.
9. Align the new riser board with the PCI riser board bracket (E).
10. Secure it with the screws provided with the kit (F).
11. Insert the riser board connector in the onboard expansion slot making sure
the board is properly seated in the slot (G).
12. Tighten the three screws to secure the PCI riser board assembly to the
chassis (H).
If you are installing
Then use
Secure it with
A two-slot riser board
The PCI riser bracket provided with the kit
Four screws
A single-slot riser board
The default PCI riser bracket
Two screws
IMPORTANT
Make sure the mounting bracket does not pinch any cables under the
bracket.
F
E
F
G
H
H
H