Rockwell Automation 6181F_P Series E Integrated Display Computers User Manual User Manual
Page 47
Rockwell Automation Publication 6181P-UM002D-EN-P - February 2014
47
Component Replacement
Chapter 4
3. Remove the screw that secures the slot cover (A).
4. Pull out the slot cover (B) and store it.
5. Remove the add-in card from its protective packaging.
6. Slide the add-in card into a compatible riser-board slot (C).
Press to make sure it is firmly seated in the slot.
7. Secure the add-in card with the screw (D).
8. Connect any necessary cables to the add-in card.
9. Refer to any installation instructions that came with the add-in card to
verify that all installation steps are followed.
10. Reinstall the computer cover as detailed in
Reinstall the Cover on page 38
11. Follow the steps for
.
ATTENTION: Do not discard the slot cover. If the add-in card is removed in
the future, the slot cover must be reinstalled to maintain proper cooling.
B
A
D
C