Replace a standard computer drive – Rockwell Automation 6181F_P Series E Integrated Display Computers User Manual User Manual
Page 43
Rockwell Automation Publication 6181P-UM002D-EN-P - February 2014
43
Component Replacement
Chapter 4
9. Hold the new drive by its edge and remove it from its protective packaging.
10. Align the new drive on the carrier (F).
11. Connect the power and data cables to the drive (G).
12. Secure the new drive to the carrier with the four screws (E).
Torque the screws to 0.452 N•m (4 lb•in).
13. Use the extended carrier lever to slide the assembly into the drive bay (H).
14. Retract the carrier lever (I) and tighten its screw to lock in place ( J).
15. Secure the drive assembly with the one screw (K).
16. Follow the steps for
.
Replace a Standard Computer Drive
The drive (HDD or SSD) in standard computers is under the power adapter
assembly.
Follow these steps to replace the drive.
1. Follow the steps for
2. Disconnect the DC barrel connector from the power input jack.
for more information on the DC barrel connection.
A
C
B
D
Extended
Carrier Lever
E
E
E
E
F
G
Extended
Carrier Lever
I
H
K
J