Rockwell Automation 6181F_P Series E Integrated Display Computers User Manual - Manual (Page 27)

Rockwell Automation Publication 6181P-UM002D-EN-P - February 2014 27
Installation Chapter 2
Connect Peripherals Connect the required peripherals, such as keyboard and mouse, to the
corresponding I/O ports on the computer. Refer to the appropriate illustrations
for connector locations in
Hardware Features starting on page 13 .
Display computer models with aluminum bezels have USB ports located on both
the I/O port side panel and the front panel. Use these ports to connect various
USB devices to the computer, such as an external drive. The front USB port is
enabled or disabled through settings in the BIOS set-up menu.
Connect Power The computer connects to either a 100…240V AC or 18…32V DC power source,
depending on the model.
Operate the computer in an industrial or control room environment, which uses
some form of power isolation from the public low-voltage mains.
No. Description
1 Front access cover
2 USB device port, Type A
3 USB key
1
2
3
ATTENTION: When connecting power to the computer for the first time, the
following actions happen:
• The default BIOS setting automatically starts the computer after it is plugged
into a power source.
• You must read and accept an End User Setup procedure for computers with a
Windows operating system.
Do not disconnect power from the system until after the Windows Setup
procedure is completed. Disconnecting power during this procedure can result
in a corrupted system image.
ATTENTION: Supply the computer circuit with its own disconnect. Use an
uninterruptible power source (UPS) to protect against unexpected power failure
or power surges.
Always shut down the Windows operating system before disconnecting power to
the computer to minimize performance degradation and operating system failures.