Rockwell Automation 6181F_P Series E Integrated Display Computers User Manual User Manual
Page 44
44
Rockwell Automation Publication 6181P-UM002D-EN-P - February 2014
Chapter 4
Component Replacement
3. Remove the four screws that secure the power adapter assembly (A).
4. Remove the power adapter assembly from the chassis (B).
5. Remove the four screws that secure the drive assembly (C).
6. Lift the bottom end of the drive metal frame about 45
°
from the chassis (D).
7. Remove the four screws that secure the drive (E).
8. Slide the default drive out of its metal frame (F).
9. Hold the new drive by its edge and remove it from its protective
packaging.
10. Slide the new drive into its metal frame and make sure it’s properly engaged
to the power and data cables (G).
11. Secure the drive to its frame with four screws (H).
12. Lay the bottom end of the drive metal frame on the chassis (I).
13. Secure the drive assembly with the four screws ( J).
TIP
Refer to
Figure 12 on page 45
for the corresponding letters in parentheses in
steps 5 though 13.
A
B
A
A
A