Rockwell Automation 6181F_P Series E Integrated Display Computers User Manual - Manual (Page 26)

26 Rockwell Automation Publication 6181P-UM002D-EN-P - February 2014
Chapter 2 Installation
9. Repeat this process at least three times until the clips are hand-tight and
the gasket is compressed uniformly against the panel.
10. Tighten the mounting clips to a torque of 1.35 N•m (12 lb•in) by
following the torquing sequence on the previous page, making sure to not
overtighten.
11. Repeat this process at least three times until the clips are properly torqued,
making sure the gasket is compressed uniformly against the panel.
Mount the Non-display Computer to a Wall
Follow these steps to mount a non-display computer.
1. Verify the power is disconnected.
2. Drill holes in the wall to accommodate M5-sized screws.
3. Mount the computer to the wall by using four M5 pan head screws.
Tighten to a torque that is appropriate for the screw and wall material.
The illustration shows the mounting hole locations with dimensions in mm (in.).
ATTENTION: Tighten the mounting clips to the specified torque to
provide a proper seal and prevent damage to the product. Rockwell
Automation assumes no responsibility for water or chemical damage to
the computer or other equipment within the enclosure because of
improper installation.
335 (13.20)
190 (7.50)