Rockwell Automation 6181F_P Series E Integrated Display Computers User Manual - Manual (Page 37)

Rockwell Automation Publication 6181P-UM002D-EN-P - February 2014 37
Component Replacement Chapter 4
Post-configuration Follow these steps after installing or removing a hardware component.
1. Make sure all components are installed according to instructions.
2. Make sure that no tools or loose parts are left inside the computer.
3. Reinstall any expansion boards, peripherals, and system cables that were
previously removed.
4. Reinstall the cover according to the instructions on page 38 .
5. Reconnect all external cables and power to the computer.
6. Press the computer’s power switch to start the computer.
Required Tools The following tools are required for component replacement:
• #2 cross-head screwdriver
• Antistatic wrist strap
• Side cutters (for cutting cable ties, if necessary)
Remove the Cover To install, replace, or upgrade internal computer components, you must first
remove the cover. The procedure for removing the rear cover is different for the
computer models.
Performance and Non-display Computers
Follow these steps to remove the rear cover (the performance computer is shown).
1. Follow the steps for Pre-configuration on page 36 .
2. Loosen the three screws that secure the rear cover (A).
3. Open the cover (B) and detach it from the chassis (C).
4. After installing, replacing, or upgrading internal computer components,
reinstall the cover as detailed in Reinstall the Cover on page 38 .
A
B
A
A
C
C