Rockwell Automation 6181F_P Series E Integrated Display Computers User Manual - Manual (Page 28)

28 Rockwell Automation Publication 6181P-UM002D-EN-P - February 2014
Chapter 2 Installation
Connect AC Power
A grounded, 3-prong IEC60320-C13 power cord provides power to the
computer. The power supply input accepts 100…240V AC and is autoranging.
Performance and Non-display Computers
Follow these steps to connect performance and non-display computers to an AC
power source.
1. Connect the power cord to the AC power input (A).
2. Secure the power cord in place with the retention clip (B).
3. Connect the AC power cord to a power source.
4. Apply 100…240V AC power to the computer.
Standard Computers
Follow these steps to connect standard computers to an AC power source.
1. Connect the power cord to the AC power input (A).
2. Secure it in place with the retention clip (B).
TIP If using an alternate IEC60320 cord, make sure the female end of the cord is
sized appropriately for the retention clip.
SHOCK HAZARD: Connect the AC power cord to a power source with an
earth ground. Failure to follow this warning can result in electrical shock.
B
A
A
B