Rockwell Automation 6181F_P Series E Integrated Display Computers User Manual - Manual (Page 50)

50 Rockwell Automation Publication 6181P-UM002D-EN-P - February 2014
Chapter 4 Component Replacement
13. Reinstall the rear cover as detailed in Reinstall the Cover on page 38 .
14. Follow the steps for Post-configuration on page 37 .
Replace or Add
Memory Modules The computers have two dual-channel DDR2 DIMM slots that support up to
4 GB maximum system memory.
Figure 13 - Memory Module Slots and Module Alignment
Memory Configuration Guidelines
Follow these guidelines when replacing or adding memory to the computers:
· Use only standard unbuffered memory modules that conform to both
PC2-3200 and SPD compliance industry standards.
· Use only DDR-II type memory modules.
· Use only memory modules with gold-plated contacts.
· Always handle a memory module by its edges.
If you intend to install Then
A compatible add-in card now Proceed to page 46 for instructions.
An add-in card later 1. Reinstall the rear cover.
2. Apply power to the computer.
ATTENTION: Some older Microsoft Windows operating systems limit the
maximum usable memory capacity to approximately 3 GB.
IMPORTANT We recommend that you use only Allen-Bradley approved memory
modules. Refer to
http://ab.rockwellautomation.com/Computers for
qualified replacement parts and accessories.
Retaining Latch
Keyed Surface
of DIMM Slot