Rockwell Automation 6181F_P Series E Integrated Display Computers User Manual - Manual (Page 41)

Rockwell Automation Publication 6181P-UM002D-EN-P - February 2014 41
Component Replacement Chapter 4
Load a Card in the Bottom CF Card Slot
Follow these steps to load a CF card in the bottom card slot of performance and
non-display computer models.
1. Loosen the two screws that secure the CF card slot cover.
2. Remove the CF card slot cover.
3. Insert the CF card into the slot until it is firmly seated.
4. Reattach the CF card slot cover.
5. Tighten the two screws to secure the slot cover.
IMPORTANT The CF card slot on the bottom of performance and non-display computers is
hot-swappable. You can insert or remove a card from this slot while the
computer is on.
ATTENTION: When properly seated, more than 80% of the CF card easily
inserts into the slot before you encounter resistance. If you encounter
resistance before then, remove the card, rotate it 180°, and reinsert.
Do not force the card into the slot. Forcing the card into the slot can
damage the connector pins.
Bottom View of Non-display Computer