Rockwell Automation 1758 DataSite Accelerator Toolkit - Manual (Page 37)

Publication IASIMP-QS008A-EN-P - March 2009 37
DataSite and Logix Integration Chapter 3
Follow these steps to download the WATTCP.CFG and MNET.CFG configuration files from the
DataSite Accelerator Toolkit CD to the ProSoft Modbus module.
1. On the toolkit CD, choose DataSite to ControlLogix Master>ProSoft Interface Module Files,
then copy the files MNET.CFG and WATTCP.CFG to your desktop.
2. Install the ProSoft
Modbus module into slot
2 of the Logic chassis.
Slot 2 is used in this quick
start. If you change the
slot number, then you
must modify the .acd
Logix program.
3. Apply power to the
chassis.
4. Connect the serial cable
that ships with the ProSoft
module between the
serial port on your
computer and the (RJ45)
CFG port on the ProSoft
module.
To CFG
(RJ45) Port
Slot 2
Cable Shipped with ProSoft Module
192.168.10.95
ProSoft Module, Slot 2
192.168.90.94
EN
B
T
P
roS
oft
To Serial COM Port
TIP
Disconnect the serial cable that you previously used to connect
your computer to the DataSite unit.