Rockwell Automation 1758 DataSite Accelerator Toolkit - Manual (Page 42)

42 Publication IASIMP-QS008A-EN-P - March 2009
Chapter 3 DataSite and Logix Integration
Connecting All Devices
At this point all devices should be connected as shown in the illustration. Modify any previous
connections, if necessary, to match the illustration.
You must use an Ethernet crossover cable to connect the DataSite unit to the radio. The cable
between the Ethernet switch and the ProSoft MVI56-MNET Modbus module must connect to the
RJ45 Ethernet Port; not the CFG port.
The configuration of the Ethernet radio modems is not covered in this quick start. Refer to your
radio user manual for instructions on how to configure and assign IP addresses to both radios.
After wiring is complete, apply power to all devices.
TIP
Radios are optional. If your application does not require radios simply replace the radios
with an Ethernet straight-through cable connecting the DataSite to the Ethernet switch.
2711P PanelView Plus 1000 Terminal
with Built-in Ethernet Port
Laptop
Ethernet Switch
Radio
Et
he
rnet
1756-L63 ControlLogix Controller
with 1756-ENBT Ethernet/IP and ProSoft Module
Pr
oS
oft
EN
B
T
L6
3
Chassis
Remote Location Host Location
Radio
All devices connect to Ethernet switch using Ethernet straight-through cables.
2711
P-
C
B
L-
EX
04
Cr
oss
over
Cable
1758-FLO302 Datasite