Rockwell Automation Logix5000 Control Systems: Connect PowerFlex 525 Drives over EtherNet/IP Quick Start - Manual (Page 21)

Rockwell Automation Publication IASIMP-QS036A-EN-P - April 2013 21
Add a PowerFlex 525 Drive to a Controller Project Chapter 2
Add the Drive to the Controller Project
1. Verify that your controller project is
offline and the Logix5000 controller is
in PROG mode.
2. Right-click your network port and
choose New Module.
The Select Module Type dialog box appears. Note that the Select Module Type dialog box can appear
differently depending on which Logix5000 controller your application uses and, thus, what version of
controller software is used.
3. Select the PowerFlex 525-EENET
drive module.
4. Check Close on Create at the bottom
of the dialog box.
5. Click Create.
IMPORTANT The tasks described in this section use a RSLogix 5000 project for a CompactLogix 5370 L3 controller. CompactLogix 5370 L3
controllers require that you use RSLogix 5000 software, version 20.00.00 or later. The Studio 5000 Logix Designer application
version 21.00 or later can also be used. The steps are very similar to the RSLogix 5000 project shown in this section.
If you are using a different Logix5000 controller, your project’s RSLogix 5000 software version requirement can be different.
RUN
REM
PROG