Rockwell Automation Logix5000 Control Systems: Connect PowerFlex 525 Drives over EtherNet/IP Quick Start - Manual (Page 24)

24 Rockwell Automation Publication IASIMP-QS036A-EN-P - April 2013
Chapter 2 Add a PowerFlex 525 Drive to a Controller Project
When the connection is complete, the Upload dialog box appears.
15. Click Upload Entire Device.
An Upload dialog box appears and
shows the progress of the upload.
If there are any differences between the
drive in your project and the drive to
which you are connecting, a Module
Definition Differences Found dialog
box appears and shows the differences. If
this is the drive you want to add to your
project, click OK. Otherwise, click
Cancel and repeat step
12 through step
15 .
16. When the Module Definition dialog box
appears, click OK.
The PowerFlex 525 is added to the
controller organizer under the network
port.
17. Save the project.