Rockwell Automation FlexPak 3000 DC Drive Version 4.3 - Manual (Page 2)

©2004 Rockwell Automation. All rights reserved.
The information in this manual is subject to change without notice.
Throughout this manual, the following notes are used to alert you to safety considerations:
Important: Identifies information that is critical for successful application and understanding of the product.
The thick black bar shown on the outside margin of this page will be used throughout this instruction manual to
signify new or revised text or figures.
!
ATTENTION: Identifies information about practices or circumstances that can lead to personal
injury or death, property damage, or economic loss.
Reliance, FlexPak, AutoMax, and E.S.P. are trademarks of Rockwell Automation.
Trademarks not belonging to Rockwell Automation are property of their respective companies.
!
ATTENTION: Only qualified electrical personnel familiar with the construction and operation of
this equipment and the hazards involved should install, operate, or service this equipment. Read
and understand this manual in its entirety before proceeding. Failure to observe this precaution
could result in severe bodily injury or loss of life.
ATTENTION: 380/415 VAC-rated FlexPak drives can be configured for either 380 VAC or 415
VAC input power. Before input power is applied to the drive, verify that the control transformer
taps are set to match the input power. Follow the instructions provided in chapter 3 of this manual
to set the control transformer taps. Failure to observe this precaution could result in damage to,
or destruction of, the equipment