Rockwell Automation FlexPak 3000 DC Drive Version 4.3 - Manual (Page 73)

Compliance with European Union Electromagnetic Compatibility Standards B-1
A
PPENDIX
B
Compliance with European Union
Electromagnetic Compatibility
Standards
This appendix provides information on installing FlexPak 3000 drives for compliance
with European Union Electromagnetic Compatibility (EMC) Standards. It covers:
• requirements for standards compliance.
• guidelines on installing the AC mains filter and inductor.
• instructions on how the drive must be installed, wired, and grounded for
compliance. These instructions are in addition to the normal installation
instructions.
Important: This appendix is not applicable to FlexPak 3000 drives rated above
300 HP @ 460 VAC. These drives are not designed to be CE-compliant.
B.1 EMC Compliance Requirements
For the FlexPak 3000 drive to conform to the standards listed on the Declaration of
Conformity (DOC), the drive must:
• be accompanied by the DOC for that drive. If you need a copy of the DOC, call the
Autofax product information system at 440-646-7777 and request the FlexPak
3000 DOC.
• be specified by model number on the DOC.
• have a CE mark, which is below the drive nameplate.
• be mounted and wired on the conductive, non-coated back panel of an electrical
cabinet.
• include an AC mains filter and inductor as specified in this appendix.
• be installed according to the instructions in this appendix.
• be operated with the electrical cabinet doors closed.
Important: Conformity of the FlexPak 3000 Drive does not guarantee that the entire
installation will be in conformance.