AJA Ki Pro Mini - Manual (Page 33)

KiPro Mini v4.2 www.aja.com 33
If Ki Pro Mini cannot get an address from the DHCP server on the LAN while Ki Pro Mini is
set to DHCP via parameter 50.1, it will then automatically drop back to a preset factory IP
address of 192.168.0.2. In this instance you can follow these alternate steps to
communicate with Ki Pro Mini:
1. Set the computer’s Ethernet IP address to 192.168.0.n (where n is not 2).
2. Set the computer’s Subnet mask to 255.255.255.0 (most computers default to the
proper netmask when the address is set).
3. Run a browser on the computer and type “192.168.0.2” (the factory fallback IP
address). You should now see Ki Pro Mini’s browser status screen.
NOTE: If Ki Pro Mini fails to find a DHCP server via its network connection, it will fall back to using the
factory default static IP of 192.168.0.2—or whatever IP address you’ve previously defined. AJA
recommends you define a Static IP address with parameter 50.2 so you’ll be prepared in the
event your DHCP server fails.