AJA Ki Pro Mini - Manual (Page 50)

KiPro Mini v4.2 www.aja.com 50
19.4 CUSTOM TAKE This parameter defines a custom take. The custom take number is defined via the front
panel select and adjust up/down arrows.
22.1 GANG CLIP NAME This parameter is used when performing gang recording via multiple Ki Pros and/or Ki
Pro Minis (refer to Controlling Multiple Ki Pros later in this manual). If the desire is to have
clips named the same across all Ki Pro ganged units' recordings, then use the "Master
Name" selection in this parameter. If the desire is to have clips named independently on
Ki Pro units, then "Slave Name" should be selected. Selecting "Slave Name" means that
the recording will take its name from the individual Ki Pro's parameters and not accept
the value pushed to the Slave by the Master Ki Pro.
NOTE: Most gang controls are only available in the web user interface.
CONFIG menus
When we talk about menus, we discuss the Parameter Number and Name on the top line
of the display and the Parameter Setting(s) possible as shown on the bottom line of the
display; remember, the current setting is what is shown.
As in the MEDIA menus already presented, pressing one of the parameter Adjust buttons
changes the current CONFIG parameter’s value to a new one from the Ki Pro Mini’s list of
choices—repeating the list if you continue to press Adjust—or adjusting a numerical
value up or down.
The exact choices displayed will vary depending on the parameter. Most adjustment
choices made with the Adjust buttons take effect immediately and will be subsequently
stored into the Ki Pro Mini’s non-volatile memory if they remain unchanged for 3
seconds.
If a Select or Adjust button is held down continuously, the changes will begin to happen
automatically - with acceleration if applicable.
Holding down both the Adjust (up) and Adjust (down) buttons—at the same time —will
set that parameter back to its factory default value.
The CONFIG menu is for system set-up and configuration. Each parameter is numbered,
just like the MEDIA menus.
1 to 999
(default = 1) Press ADJUST button up or down to change the
TAKE value from 1 to 999, if a value other than the
automatically generated value is desired.
Master Name (default)
Slave Name
Enable have clips named the same across all Ki Pro ganged
units
Name clips independently on Ki Pro units