AJA Ki Pro Mini - Manual (Page 60)

KiPro Mini v4.2 www.aja.com 60
50.2 IP ADDRESS This parameter determines the static IP address used by Ki Pro Mini for TCP/IP
networking:
NOTE: For parameters 50.2, 50.3, and 50.4, you will be setting IP addresses that consist of “octets”
separated by a period (i.e., 10.0.181.0). When editing these, the Select button selects the octet
and then the Adjust buttons select the desired number. Pressing Select Up again advances to
the next octet. At the final octet, the address will flash—pressing Select Up at that point
confirms the setting.
When these parameters are edited, you can abort the editing process by backing out (press
the Select down arrow button repeatedly until the edit passes the first octet). You’ll notice that
after completing the edit on the last octet, the display will blink—this is an indication that the
edited IP address is about to be saved. You can save the edited IP address (press the Select
arrow up to save) or choose not to save by pressing the Select arrow down button.
50.3 SUBNET MASK This parameter determines the subnet mask used by Ki Pro Mini for TCP/IP networking:
NOTE: The note about editing IP addresses in parameter 50.2 also applies to parameters 50.3 and
50.4.
DEFAULT ADDR
DHCP (default) Use the factory default static IP address: 10.65.74.65
Select automatic IP address assignment from DHCP
server on LAN.
Note: if Ki Pro Mini cannot find a DHCP server with which to
communicate, it will select the default factory IP address of
192.168.0.2.
variable Using the adjust buttons, enter an IP address compatible with
your LAN (if you have one). If direct connecting to a computer,
enter a legal IP address that you’ll also enter in the computer’s
web browser. This is only needed for Static IP configurations.
If 50.1 is set to DHCP and there is a DHCP failure, then the
default IP address is: 192.168.0.2
If 50.1 is set to Default Addr, the default static IP address is:
10.65.74.65
variable Using the adjust buttons, enter a subnet mask compatible with
your LAN (if you have one). This is only needed for Static IP
configurations.
If 50.1 is set to DHCP, the default Subnet Mask will be assigned
by the DHCP server
If 50.1 is set to Default Addr, the default Subnet Mask is:
255.0.0.0