Metrohm viva 1.1 - Manual (Page 21)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1 Introduction
viva 1.1
￭￭￭￭￭￭￭￭ 9
￭ Call command CALL ELECTROLYTE
Command for calling a VA track. The data acquired in the called VA
track is used in the RC (Response Curve) calibration method for the
determination of additives with a suppressing effect (e.g. leveler).
￭ Dosing command SET TOTAL VOLUME
The SET TOTAL VOLUME command is a dosing command for the
manual entry of the current total volume in the measuring vessel, e.g.
after automatic rinsing or a manual exchange of solution.
Workplace program part
￭ Peak result display
The peak evaluation results (peak potential and area or height) are
shown in the live display directly after the evaluation.
Database program part
￭ Show "Reprocessing with history"
Status display in the Reprocessing dialog window indicating whether
Reprocessing with history is activated or deactivated.
￭ "Send with history"
Users can select whether they want to send all versions or only the first
and the last version of a determination.
￭ "Export with history"
Users can select whether they want to export all versions or only the
first and the last version of a determination. The export of several
determinations at the same time is now much faster.
￭ Report templates expanded
All report templates with measurement curve display have been expan-
ded such that the measurement curves of all commands are displayed.
When updating from viva 1.0 to viva 1.1, an additional, revised report
template is installed for each report template installed in viva 1.0. All
old report templates with the date Saved = 2013 and Saved by =
Metrohm can be deleted.
Method program part
￭ Fixed point evaluation
Fixed point evaluations allow users to obtain the measured value for
the current or the potential at a previously defined potential or time.
Configuration program part
￭ Setting the option Reprocessing with history
With the new option Reprocessing with history, users can select
whether all recalculated versions of a determination (option: on) or
only the last and the original determination (option: off) are to be
saved in the database. The default setting is off.