Metrohm viva 1.1 - Manual (Page 499)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.1
￭￭￭￭￭￭￭￭ 487
Sensor
Colorimetric sensor
Selection of a colorimetric sensor from the table of colorimetric sensors.
The calibration data for the colorimetric sensor will be adopted for the
determination.
Selection 'Name of the colorimetric sensor' | empty or
'first list entry'
Default value empty or 'first list entry'
Temperature measurement
Type of temperature measurement
Displayed only when Device type = 089 Photometer.
Selection continuous | off
Default value continuous
continuous
A temperature sensor must be connected. The temperature will then
be measured continuously.
off
The temperature will not be measured. The temperature entered man-
ually under Temperature on the Measuring parameters tab will be
used.
Stirrer
This section is displayed only when Device type = 089 Photometer.
Stirrer
Selection of the stirrer.
Selection 1 | off
Default value 1
off
Means that no stirrer will be used.
Stirring rate
Setting the stirring rate.
Input range 0 - 15
Default value 3