Metrohm viva 1.1 (ProLab) - Manual (Page 188)

3.9 Curves subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
176 ￭￭￭￭￭￭￭￭
viva 1.1 (for process analysis)
CPVS
Selection
Current [A] | Potential [V] | Time [s] | Current
measuring range [A]
Default value Current [A]
CP
Selection
Current [A] | Potential [V] | Time [s] | Potential
measuring range [V]
Default value Potential [V]
Label
Freely definable axis label for the y1 axis. If auto is selected, then the des-
ignation from the Quantity field will be used.
Selection 50 characters | auto
Default value auto
Numerical format
Selection of the numerical format for the labeling of the y1 axis.
Selection decimal | scientific | engineering
Default value engineering
decimal
The axis is labeled in the decimal format ±##.### (floating-point num-
ber).
scientific
The axis is labeled in the scientific format ±#.###e±###.
engineering
The axis is labeled in the technical format ±###.###+prefix (engi-
neering format). The prefix (m, µ, n, p) is added to the figure.
Scaling
on | off (Default value: off)
If this check box is activated, then the y1 axis can be manually scaled in
the curve window. In this case, the Start value and End value fields can
be edited. If this check box is not activated, then the y1 axis will be auto-
matically scaled.
Start value
Initial value for scaling the y1 axis.
Editable only when autoscaling is disabled.
Input range
-1.00E+12 - +1.00E+12
Default value -1.00E+12