Metrohm viva 1.1 (ProLab) - Manual (Page 474)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
462 ￭￭￭￭￭￭￭￭
viva 1.1 (for process analysis)
NOTE
Volumes dosed into the measuring cell with the LQH command are not
taken into account in the volume bookkeeping of a quantitative deter-
mination. It is mandatory that the ADD commands be used in such
cases.
Instruments
This command can be executed with the following instruments to which a
Dosino 800 is connected:
Voltammetry: 894
Dosing Interface: 846
Sample changer: 814, 815, 858, 919
Photometer: 089
Appearance
The command has the following appearance:
Parameters
The parameters for the LQH command are set on the following tabs:
￭ General/Hardware
Parameters for instrument and dosing device.
￭ Parameters
Parameters for setting the Liquid Handling function.
Command variables
The following command variables are generated by the LQH command in
the method run and can be used in formulas under the designation 'Com-
mand name.Variable identification':
Identification Description
BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started
CYL Cylinder volume of the dosing unit used for the com-
mand