Metrohm viva 1.0 (process analysis) - Manual (Page 326)

4.6 Curves subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
314 ￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
Start value
Initial value for scaling the y1 axis.
Editable only when autoscaling is deactivated.
Input range
-1.00E+12 - +1.00E+12
Default value -1.00E+12
End value
End value for scaling the y1 axis.
Editable only when autoscaling is deactivated.
Input range
-1.00E+12 - +1.00E+12
Default value +1.00E+12
Curve
Axis label
Selection of the color for the designation of the y1 axis.
Selection 13 colors | black
Default value black
Symbol
Selection of the symbol for the display of the individual measuring points.
Selection ● | ╳ | ✸ | ￭ | ▲ | no symbol
Default value no symbol
no symbol
Measuring points are not shown.
Show original curve
on | off (Default value: off)
If this check box is activated, then the original curve will be displayed
instead of the smoothed curve.
Show spikes
Symbol
Selection of the symbol for the display of spikes.
Selection ● | ╳ | ✸ | ￭ | ▲ | no symbol
Default value no symbol
no symbol
Spikes are not shown.